Blanco BCG641WX User Manual

CONVERSIONS
9) U-LPG TO NATURAL GAS CONVERSION
PROCEDURE
Appliance models: Gas stainless steel hotplate
models:
BCG640 4Burners
BCG641
4 Burners
1.
Remove each bumer cap and burner skirt.
2. Remove the U-LPG main injector with a 7 mmNF
tube spanner and replace with the appropiate size
Natural Gas injector for each burner. The following
injector sizes are required for Natural Gas:
Burner
Wok
Rapid
Semirapid
Auxiliary
Main injector
3. Shut off gas supply to the appliance.
4. Disconnect gas inlet pipe from the U-LPG Gas
test point inlet fitting.
5. Remove the U-LPG test point inlet fitting from the
appliance.
6. Fit the Natural Gas Regulator supplied in the
conversion kit.
7. Connect the gas supply to the Regulator.
8. Check for gas leaks. Do not use a naked flame to
check for gas leaks.
9. Adjust the gas pressure to 1 .OO kPa.
10. Remove the control knob, with a thin shaft blade
screwdriver down the centre of each gas valve
shaft, screw the by-pass injector anti-clockwise.
Test the appliance on both high and low flame for
each burner. If the burner fails to remain alight or
the flame is not stable on the simmer setting, adjust
the by-pass screw, until flame is stable.
11. If not already removed, remove the "Only for
use with U-LPG" label adhered to the botto~ panel
near the gas connection.
10 NATURAL GAS TO UNIVERSAL
L
IJ G CONVERSION PROCEDURE
Appliance models: Gas stainless steel hotplate
models:
BCG640 4 Burners
BCG641 4Bumers
1.
Remove each bumer cap and burner skirt.
2. Remove the Natural Gas main injector with a 7
mmlVF tube spanner and replace with the
appropriate size U-LPG main injector for each
burner. The following injector sizes are required for
U-LPG:
Burner
Wok
Rapid
Semirapid
Auxiliary
Main injector
3. Remove the control knob, with a thin shaft blade
screwdriver down the centre of each gas valve
shaft, screw the by-pass injector fully clockwise.
4. Shut off gas supply to the appliance.
5. Disconnect gas inlet pipe from the Natural Gas
Regulator.
6. Remove the Natural Gas Regulator from the
appliance.
7. Fit the U-LPG test point inlet fitting supplied in the
conversion kit.
8. Connect the gas supply to the inlet fitting.
9. Check for gas leaks. Do not use a naked flame to
check for gas leaks.
10. Adjust the gas pressure to 2.75 kPa.
11. Test the appliance on both high and low flame
for each bumer and check the gas pressure. If the
burner fails to remain alight or the flame is not
stable on the simmer setting, adjust the by-pass
screw, until flame is stable.
12. If not already removed, remove the "Only for
use with Natural Gas" label adhered to the bottom
panel near the gas connection.

Blanco BCG641WX Specifications

General

Brand	Blanco
Model	BCG641WX
Category	Cooktop
Language	English