CONVERSIONS
11)
REPLACING THE INJECTORS
The burners can be adapted to different types of gas
by installing injectors suited to the type of gas
required. To do this, first remove the burner tops
using a wrench
"B".
Now unscrew injector
"A
(see
fig.
17)
and fit a injector corresponding to the type of
gas required.
It is advisable to tighten the injector in place.
'
After the injectors have been replaced, the
burners must be regulated as explained in
paragraphs
8.
The
technician must
reset
any seals
on the regulating or pre-regulating devices and
affix the label corresponding to the new gas
regulation on the appliance instead of the already
e;cisting one. This label
is
supplied in the packet
containing the spare injectors.
The envelope with the
injectom and the labels can
be included in the kit, or at disposal to the
authorized customer
Se~.ce Centre.
For the sake of convenience, the nominal rate chart
also lists the heat inputs of the burners, the diameter
of the injectors and the working pressures of the
various types of gas.
"
BURNER ARRANGEMENT ON ME HOT PLATE
U-LPG
12.0
1 1
NATURAL
1
1.00 12.0
----
-
TABLE
U-LPG
I
2
I I
6.9
7.3
BURNERS
H"I
DESCRIPTION
U-LPG
2'75
1
15.0
1
ULTRAR*AD
1
NATUFUL 1.00 15.0
NORMAL
PRESSURE
pa)
GAS
3
FIG.
17
INJECTOR
DIAMETER
enw
mm)
AUXILIA~
-
&
NOMINAL
HEAT
INPUT
(MAIIJ/h)
MAX
,
U-LPG 2.75
1.00
54
90
3.8
4.2
To Next Page
Loading...
Need help?
General
