Blanco BDW 203 - Before First Use; Rinse Aid Usage; Rinse Aid Dose Adjustment

Before use
Before using your dishwasher for the first time:
1. ensure that the electrical and water connections
comply with the installation instructions:
2. remove all packaging from inside the appliance
3. fill the rinse aid dispenser
Rinse aid
Rinse aid is automatically added during the last
rinse, ensuring through rinsing, spot and streak
free drying. The dispenser, which is positioned
inside the door, holds about 110 ml of rinse aid,
which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid:
1. Open the container by turning the lid (A)
anticlockwise.
2. Add the rinse aid until the container is
completely full. The indicator (B) will be
completely dark.
3. Top up the rinse aid when the indicator (B)
| becomes clear.
Ensure that the lid is closed after every refill.
Do not put liquid detergent in the rinse aid
department. Clean up any rinse aid spilt during
filling with an absorbent cloth to avoid excess
foaming during the next wash.
Adjusting the dose
According to the finish and drying results obtained,
adjust the dose of rinse aid by means of the 6
position selector (C) (position 1 minimum dosage,
position 6 maximum dosage).
Start from position 3.
Gradually increase the dose if there are drops of
water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish streaks on the
dishes.
PFRO4GB