Blanco BDW 203 - Operating Sequence; Filter Check; Rinse Aid Check; Dish Loading Procedure

Operating sequence
1. Check the filters
Ensure they are clean and properly
positioned (see cleaning instructions).
Check that there is rinse aid
Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
Saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, Saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
Ensure that the spray arms can
rotate freely.
Measure out detergent
Add the required amount of detergent into
the dispenser according to the "Washing
programmes" chart and close the lid.
Close the detergent dispenser
lid
Close the dishwasher door
Set the programme
Tum the programme selector dial clockwise
until the letter of the programme you wish
to select corresponds with the programme
marker.
If necessary select the temperature of the
main wash according to the instructions in
the "Washing programmes" chart (see
"Required pushbuttons").
10.
11.
Start the programme
Depress the On/Off button.
The On/Off indicator light will come on
and the machine will start.
If you wish to interrupt the wash
programme at any time press the button
again.
At the end of the washing
programme
At the end of the washing programme the
machine stops automatically.
The On/Off indicator light remains on
until the On/Off button is depressed.
Switch off the dishwasher
Switch off the dishwasher by pressing the
On/Off button and open the door.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working, if
the door is opened however, a safety
device ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
FOS20GB