Blanco BDW146X - Cleaning the Filter; Cleaning the Door; Protect against Freezing; Cleaning the Spray Arms

The cont ro l p ane l can be clea ned by u si ng a lig htly dampen ed c loth.
Afte r cleaning, m ake sure to dry it tho roug hly.
For the ext e ri or, us e a good applia nc e poli s h wax.
Never use s harp object s, scouring pa ds o r h ar sh clean er s on a ny p art o f t he dis hw asher.
Protect Again st Freezing
1.Cut off the electrical power to the dishwasher.
2.Tur n of f the water suppl y an d disco nnect the w ater inl et pipe from the w ater val ve.
3.Drain th e w ater from the inlet pipe an d water va lve. (Use a pan to gathe r th e w ater)
4.Reconnect t he water inl et pipe t o the wa ter val ve.
5.Remove the filter at the bott om o f the tub and use a spong e t o soak up wate r in t he sump.
pl ease take frost pr ot ection m easures o nt he dishw asher in winter. Every fter washing c ycles,
pl ease oper ate as follow s
time a
：
Cleaning the Filter
Cleaning The Door
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures
on the previous page and reinsert the entire assembly in the dishwash er, positioning it in its seat and pressing downwards.
When cleaning the filters, don't knock on them. Otherwise, the filters could b e
contorted and the performance ofthe dishwashercouldbe decreased.
To clean the e dge around t he door, you sho uld use o nly a soft warm, d am p cl oth.
To avoid pene trati ono f wa ter into the door l ock and el ectrical com po nents , d o no t
use a spr ay cleaner of any kind.
Never u se a spr ay cl ean er t ocle an t he door panel as i t may dam age the door loc k
and electrical components.
Abr asive ag ents or some pa pe r towels shou ld not be u sed becau se of t he r isk of
sc r a t c hi ng o r leavin g s p ots on the stainless stee l s ur fa ce.
Cleaning the Spray Arms
I f your dis hwasher cannot work beca use of the ice,
pl ease con tac t prof essional service pe rso ns.
It i s ne ces sary t o clean t h e s p r ay ar ms regula r l y for h ar d
water chemicalswillclog the spray arm jetsandbearings.
- Inspec t the filte rs fo r blockin ga fter e ver y time th e dis hwa sher ha s be en used .
- By uns crewing the coar se fi lter, y ou can rem ove the filter system . Re mov ean y foo d remna nts and
clean the filters underrunningwater.
Remarks:
The entire filter assembly should be cleaned once a week.
To removeth elower spray arm, pull out the spray arm upwa rd.
To r e move th e u pper s p ray arm, hold t he nut, r ot ate th e a rm
clockwise toremove it.
Wash the arms in soap y an d w arm water and u se a soft brush t o
clean the jets. Replace them af ter rinsin g t hem thor oughly.