Witheachwashcycle.
Compartment
For programmes with pre-wash onl y.
(Follow the )User Man ual
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a programme
Turn on the water ta p and press the . T he mac h ine will start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting fro m the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt foo d in pans,
then l oad the baskets. Ref er to the dishwasher loading inst ruct ions.
Close the door,press the Programme Button until the selected programme lights up.
( See the section entitled Operation instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he door car ef ull y.
Hot s team may escape
when the door isopened.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state.
Switch on the appliance Press the On/Off button to switch on the appliance, Op en the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the detergent
m ay have already been released and the water a lready drained. If this is the case, the detergent
dispenser must be refilled.
2.
Press the Start/Pause button, press the program button for more than three seconds, the
machine will be in standby state, then you can change the program to the desi red cycle setting
1.Press the Start/Pause Button to st op the washing.
2.Open the door a little .
3.After the spray arm s stop working, you can open the door
c ompletely.
4.Add forgotten dishes.
5.Close the door.
6.Press the Sta rt/Pause Butt on, the dishwasher will run
after 10 seconds.
To Next Page
Loading...
Need help?
General
