EasyManua.ls Logo

Blanco BFD645X - Water Connection; Connecting the Safety Supply Hose; Disconnecting and Cold Water Connection

Blanco BFD645X
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER A NY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EAR THING
CONNECTION
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
A hosethat attachesto asink spray can burst if itis installed on thesame water lineas the dishwasher. If your sink
has one, it is recommendedthat the hoseb edisconnected andthe hole plugged.
Pull The safety supply hoses completely out from the storage compartment located at rear of
dishwasher.
T urn water fully on before starting the dishwasher.
1
Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
Thesafety supply hose consistsof the double walls. The hose's system guarantees its interventionby blocking the
f low o f wa ter in ca se of the sup ply hose bre aking a nd when t he ai r sp ace b et ween the sup ply hose itse lf an d th e ou ter
corrugated hose is full of w ater.
T urn off the water .
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
The app liance mus t be conne cted to the w ater m ains using n ew ho se-sets.
The o ld hose -se ts sho uld not be reus ed.
Waterpressure must be between 0,04 MPa and 1 MPa. Ifthepressure is below the
minimum consultour Service Departmentfor advice.
C onn ect the c old w ate r sup ply h ose to a thre aded 3/4 (inch) conne ctor and make su re th at it is fas tened t ig htly in p lace .
If the water pipes are new or have not been used for anextended period of time, let the water run to make sure that the
w ater is c lear and free of im puri ties. If th is precau tion is n ot ta ken, ther e is a ri sk th at the water inlet c an get bl ocke d
and dama ge the ap pliance.

Related product manuals