Witheachwashcycle.
Compartment
For programmes with pre-wash on ly.
(Follow the !)User Manual
Electr ic indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a programme
Turn on the water ta p and press the . T he machine will start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 mi n utes) before unload ing the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will a lso dry better.Unload the appliance, starting fro m the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oad the baskets. Refer to the dishwashe r loading instructions.
Close the door,press the Programme Button until the selected programme lights up.
( See the section entitled Operation instructi on )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he do or caref ul l y.
Hot s team may esc ape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwa sher
according to the origin al Power-on state.
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
For detailed operating method read the corresponding content on t he instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the detergent
m ay have already been released and the water a lready drained. If this is the case, the de tergent
dispenser must be refilled.
2.
Press the Start/Pause button, press the program button for more than three seconds,the
machine will be in standby state, then you can change the program to the desired cycle setting
1.Press the St a rt/Paus e Button to stop the washing.
2.Open the door a little .
3.After the spray arms stop working, you can open the door
c ompletely.
4.Add forgotten dishes.
5.Close the do or.
6.Press the Start/Pause Button, the dishwasher will run
after 10 seconds.
To Next Page
Loading...
Need help?
General
