COOKTOP BURNERS WITH FLAME FAILURE ( BFS60NXFF; BFS60WXFF )
These models are fitted with flame failure.
If the gas supply is deficient or if the flame is extinguished accidentally, the gas circuit will be
automatically closed.
To restart it is necessary to re-ignite the burner.
You will firstly need to verify that it is not a gas supply problem, wait at least one minute and
repeat the lighting.
To ignite this type of burner it’s necessary to depress and maintain pressure on the knob for 10
seconds.
After this time release the knob and the burner will then remain alight.
3.2 USING THE CERAN COOKTOP ( BFS60CX )
Avoid any shocks with saucepans etc: The glass surface is highly resistant but not
unbreakable.
Avoid rubbing with saucepans etc: as in time this will deteriorate the markings on the top of
your ceramic hob.
Avoid using saucepans with rough or dinted bases: They may hold and transport matter
liable to stain or scratch the hob.
Any such faults, which are not the cause of breakdowns nor make the hob impossible to
use, are not included in the guarantee.
Glass or porcelain saucepans may be used provided the base is flat.
The saucepan diameters should be according to the diameter of the work area.
Don’t use saucepans with a smaller diameter to the work area see this figure :
Cover the saucepan during cooking, to save energy.
Always position saucepan before switching on the cooking zone.
How to use the work area :
Operation of the work area is realised by turning the knob through 3 positions, to the selected
position ( 1 – minimum ; 3 – maximum ).
For models with double heating. To activate the double zone, turn the knob clockwise until a
click is heard. The area is then activated. To vary the control set the knob between 1 and 3.
To Next Page
Loading...
Need help?
General
