23
Operating Instructions
Adjusting the rinse aid reservoir
The rinse aid reservoir has six settings. Both the recommended setting and
the factory setting is “4”. If the dishes are not drying properly or are
spotted, adjust the dial to the next higher number until your dishes are
spot-free. Reduce it if there are sticky whitish stains on your dishes or a
bluish film on glassware or knife blades.
Filling the Detergent Dispenser
Note: Be aware that depending on the soiling of water, setting may be different.
Please observe the manufacturer's recommendations on the detergent packaging.
Add detergent into the larger cavity
(A) for the main wash cycle.
For better cleaning result, especially if
you have very dirt items, pour a small
amount of detergent onto the door.
The additional detergent will activate
during the pre-wash phase.
Open the detergent dispenser flap by
pushing the detergent dispenser
release catch.
Close the flap by sliding it to the left
and then pressing it down.
To Next Page
Loading...
Need help?
General
