Blanco BWC61BT User Manual

collection point. Follow local guidelines when disposing of waste. For more information on the treatment, re-use
and recycling of this product, please contact your local authority or domestic waste collection service.
INSTALLATION INSTRUCTIONS
Any electrical work must be undertaken by a licensed electrician. It is dangerous to alter specications in any
way.
Ensure that all packaging, both inside and outside the rangehood, has been removed before it is used.
After installation, please dispose of the packaging with due regard to safety and the environment.
• ElectricConnection
The appliance has been manufactured as a class II, therefore no earth cable is necessary.
The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral
If not provided, connect a plug for the electrical load indicated on the rating label. Where a plug is provided,
the cooker hood must be installed in order that the plug is easily accessible.
An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and
local standards, must be placed between the appliance and the network in the case of direct connection to
the electrical network.
If a connection tube composed of two parts is used, the upper part must be placed outside the lower part.
Do not connect the rangehood exhaust to the same conductor used to circulate hot air or for evacuating fumes
from other appliances generated by other than an electrical source.
Before proceeding with the assembly operations, remove the anti-grease lter(s) (Fig.5) so that the unit is easier
to handle.
In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.
•  We recommend the use of an air exhaust pipe with a diameter of 150. If a pipe with a smaller diameter is used,
the eciency of the product may be reduced and its operation may become noisier.
Warning: Failure to install the screws or xing device in accordance with these instructions
may result in electrical hazards (see technical data if supplied).
• Fixingtothewall
Depending on the installation use screws and screw anchors suited to the type of wall (e.g. reinforced concrete,
plasterboard, etc.). If the screws and screw anchors are provided with the product, check that they are suitable
for the type of wall on which the hood is to be xed.
Drill suitable holes A as per the dimension indicated (Fig.2) Fix the appliance to the wall and align it in hori-
zontally.
Secure the hood to the wall using screws A through the holes in the hood in the position shown (Fig.4).
• Fixingthedecorativetelescopicue
Arrange the electrical power supply within the area of the decorative ue. If your appliance is to be installed in
the ducting version or in the version with external motor, prepare the air exhaust opening.
Adjust the width of the support bracket of the upper ue (Fig.3) x it to the wall using the screws A (Fig.3) so it
is in line with your hood and is 20 mm from the ceiling as indicated in Fig.2.
Connect the ange C to the air exhaust hole using a connection pipe (Fig.4). Insert the upper ue into the lower
ue and rest above the frame. Extract the upper ue up to the bracket and x it with the screws B (Fig.3).
To transform the hood from a ducting version to re-circulating, please follow the instructions below. Charcoal
lters are available as an optional extra.
• Recirculatingversion
Install the hood and the two ues as described in the paragraph for installation of the hood in ducting version.
Assemble the charcoal lters refer to the instructions contained in the kit. The lters must be applied to the
suction unit positioned inside the hood. They must be centered by turning them 90 degrees until the stop catch
is tripped (Fig.6). Charcoal lters are available from your retail outlet. Product Code: ACK62836
- 6 -

Blanco BWC61BT Specifications

General

Brand	Blanco
Model	BWC61BT
Category	Ventilation Hood
Language	English