© 2011 Blastpro Manufacturing Inc.
®
when allowed to accumulate in an area. An odorless, tasteless, & non-irritating
gas, carbon monoxide can quickly become lethal. As a result, vapor propane must
be used in all instances when the work area is enclosed or partially enclosed. The
work area must still be well ventilated, however, as vapor propane also releases
carbon monoxide. This means that extreme caution must still be used when using
this fuel source.
5. Each worker has a carbon monoxide monitor on their persons. These carbon
monoxide monitors should be calibrated, in working order, & should be equipped
with audible alarms that will warn workers if carbon monoxide levels become too
high. If carbon monoxide levels exceed 35 parts per million, all work must cease
immediately. This represents a potentially deadly situation which necessitates an
immediate shutdown.
6. All operators & other personnel within the work area have received training on
proper ventilation procedures & on proper operation procedures for the engine &
for other types of equipment.
7. Floors have been thoroughly inspected. Some floor or deck surfaces may be
coated with or contaminated by dangerous materials such as:
• PCBs
• Lead
• Asbestos
• Pesticides
• Solvents
• Cleaning fluids
• And/or other harmful chemicals
The dust produced from shot blasting such surfaces can create a serious health threat
to those who inhale or come into contact with the dust. The work area must be checked
for these materials before work can begin. Blastpro manufacturing, inc. does not
warrant its equipment to be suitable for, or approved for, removing dangerous materials.
It is therefore the responsibility of the contractor to confirm the safety of the work area &
the equipment with the proper authorities. It is also the responsibility of the contractor to
warn all staff members of all the potential short-term & long-term health risks associated
with inhaling & coming into contact with dangerous materials. The contractor is
responsible for protecting all workers from being exposed to dangerous materials. Since
the shot blasting machine has not been designed to remove, clean, profile, or alter any
surface coated with or otherwise contaminated by dangerous materials, Blastpro
Manufacturing, Inc. expressly disclaims any liability for injury, illness, death, or damage
that might occur or result from such improper use.
8. Operator & any other personnel in the work area are wearing safety glasses with
side shields, dust masks, ear plugs, hard hats, steel toed work boots, long sleeved
shirts, tight fitting clothing, & gloves. It is also imperative for staff to tie back long
hair & to remove all jewelry.
To Next Page
Loading...
