What to do if there is abrasive leakage in BlastPro BP-10 SUPER?
If your BlastPro Shot Blasting Machine experiences abrasive leakage, it could stem from improper sealing. Inspect all seals for wear. Also, check the blast pattern, as an improper control cage setting can lead to leakage.
Why is there excessive wear on blast housing rebound chamber/liners in BlastPro Shot Blasting Machines?
Excessive wear on the blast housing rebound chamber or liners in your BlastPro Shot Blasting Machine is likely due to an improper setting of the control cage. Check the blast pattern and readjust it accordingly.
What to do if my BlastPro Shot Blasting Machines is hanging up?
If your BlastPro Shot Blasting Machine is hanging up, it's likely due to an uneven work surface or a floor obstruction. Try pushing down on the steering handle to raise the machine and clear small obstructions or uneven surfaces. If possible, shut the abrasive valve while clearing the obstruction and reverse direction to clear it. Use caution when raising the seal due to the risk of exposure to high-velocity abrasive.
Why will my BlastPro BP-10 SUPER not drive?
If your BlastPro Shot Blasting Machine is not driving, it may be due to the drive pin not being installed. Install the drive pin.
How to fix loss of cleaning action in BlastPro BP-10 SUPER?
If you're experiencing a loss of cleaning action with your BlastPro Shot Blasting Machine, the machine travel speed may be too fast. Adjust the travel speed to resolve this issue.
Why is the cleaning time increased on my BlastPro BP-10 SUPER?
If your BlastPro Shot Blasting Machine's cleaning time has increased, several factors could be at play. Start by checking the ammeter reading; a low reading suggests insufficient abrasive reaching the wheel. Inspect the abrasive level in the storage hopper, as it may contain excessive fines and contaminants. Also, check for any obstructions in the abrasive feed, such as the feed spout, abrasive control valve, or separator screen. Contaminated abrasive and ventilation should be checked. Wheel impeller and control cage wear can also contribute, so consider replacing the wheel kit. Ensure the drive belt has proper tension, alignment, and is free from wear. Finally, examine the blast pattern, ensuring the blast wheel is correctly seated with the wheel hub. Close and gradually reopen the abrasi...
General safety guidelines and OSHA regulations overview.
Procedures for assessing the work area before blasting operations begin.
Steps to ensure safe operation before starting the machine.
Guidelines for safe operation of the BP-10 SUPER during use.
Procedures for safely shutting down the BP-10 SUPER and dust collector.
Safety precautions for performing maintenance on the equipment.
Detailed steps and factors for setting the control cage for optimal blast pattern.
Identification and inspection intervals for parts subject to wear.
Step-by-step guide for replacing the blast wheel assembly.
Daily and periodic checks for seals, liners, and other components.
List and diagram of liners and seals with part numbers.
Exploded view and part list for the front end assembly.
Diagram and part list for major welded components.
Diagram and part list for the back end assembly.
Diagram and part list for the blast wheel assembly.
Diagram and part list for the overall machine assembly.
General| Brand | BlastPro |
|---|---|
| Model | BP-10 SUPER |
| Category | Shot Blasting Machines |
| Language | English |
To Next Page
