BlastPro BP-10 SUPER - Safety - Maintenance Procedures

9
 Empty all shot from the shot hopper on the BP-10 SUPER. Shot should never be left in
BP-10 SUPER after work is performed. Never move or transport BP-10 SUPER with
shot in the shot hopper as this may result in damage to the equipment.
 AFTER COMPLETING WORK, CLEAN ALL STRAY SHOT FROM WORK
AREA. SHOT CAN BE CLEANED WITH A MAGNETIC BROOM OR WITH A
SHOP VACUUM. NEVER LEAVE STRAY SHOT IN WORK AREA AS SHOT
REPRESENTS A SLIP AND FALL HAZARD! STEPPING AND FALLING ON
STEEL SHOT CAN RESULT IN SERIOUS INJURY OR EVEN DEATH!
Safety — Maintenance Procedures
When performing maintenance on the BP-10 SUPER, make certain that the following safety
procedures are followed:
 Verify that the BP-10 SUPER and the dust collector are not in operation. Attempting
to perform maintenance operations on the BP-10 SUPER or the dust collector while
they are in operation could lead to serious injury or death.
 Verify that all moving parts on the BP-10 SUPER have completely stopped moving.
 Make certain that all moveable parts have been secured so that accidental movement
of the BP-10 SUPER will not result in these parts moving.
 Verify that the BP-10 SUPER and the dust collector are on a level and stable surface.
 Make certain that the BP-10 SUPER is in the Safety off position (valve is closed,
blast machine is switched off, dust collector is switched off, all drives are at a
standstill, and main plug has been pulled).
 If repairing the underside of the BP-10 SUPER, then be certain to use jack stands.
Never work under equipment that is not properly blocked.
 All repairs to electrical components, including wiring, should be performed by a
licensed electrician.
 When performing electrical servicing work, maker certain that all replacement
electrical components comply with the original parts and are correctly adjusted.
 All other repairs must be completed by competent, qualified personnel.
 FAILURE TO REPLACE LOOSE OR DAMAGED PARTS COULD CAUSE
DAMAGE TO THE EQUIPMENT AND/OR SERIOUS INJURY OR DEATH
TO THE OPERATOR!
 Verify that aggressive cleaning products are not used.
 MAKE CERTAIN TO NEVER WELD, FLAME CUT/TORCH, OR PERFORM
ANY GRINDINGWORK ON THE BP-10 SUPER WITHOUT WRITTEN
AUTHORIZATION FROM BLASTPRO MANUFACTURING, INC!
 Make certain that electrical equipment is inspected regularly.
 Verify that all screw connections that were undone during maintenance work are
retightened prior to putting the machine back into operation.
 After performing maintenance operations on the BP-10 SUPER and dust collector,
verify that all safety labels, guards, control panels, housings, lids, seals, casters,
magnets and other parts that have been replaced are secure.