Blastrac BDC-66 - User Manual

Other manuals for Blastrac BDC-66

Operating Instructions27 pages

Service Manual16 pages

Questions and Answers

T
todd15Aug 3, 2025
What to do if the motor failure warning light is lit on Blastrac Industrial Equipment?
- F
  fedwardsAug 3, 2025
  If the motor failure warning light is lit on your Blastrac Industrial Equipment, it indicates that the motor protection switch has been triggered, possibly due to an incorrect power supply or defective equipment. Ensure that the power supply matches the correct voltage and Hertz. It's recommended to call a qualified electrician to inspect the motor protection switch inside the electrobox.
M
Molly GomezAug 9, 2025
Why does my Blastrac Industrial Equipment have no suction power?
- J
  Jennifer BurnettAug 9, 2025
  If your Blastrac Industrial Equipment has no suction power, several issues could be the cause. First, check and clean or replace the filter cartridges if they are dirty. Next, inspect the dust container for foreign air leaks and realign or replace the seal if necessary. Also, check the dust hose for obstructions or rips, replacing it if needed. Finally, check the tension of the blower/fan V-belt and adjust it as needed.
D
donalddiazAug 15, 2025
What to do if the phase sequence warning light is lit on Blastrac Industrial Equipment?
- J
  jasonpriceAug 15, 2025
  If the Blastrac Industrial Equipment is showing a phase sequence warning light, it means the phases of the power supply are connected incorrectly. To resolve this, you should call a skilled electrician to change the phase inversion switch inside the electrobox.
D
Dr. Alexis JacksonAug 21, 2025
Why does my Blastrac Industrial Equipment have too low or no pressure?
- T
  Tammy AndersonAug 21, 2025
  If your Blastrac Industrial Equipment has too low or no pressure, start by checking the entire pneumatic system for leaks. If you find any, repair the leaks or replace the damaged components. Also, check the air filter of the compressor; if it's dirty, clean or replace it.
S
Scott PerezAug 27, 2025
How to fix unusual noises in Blastrac Industrial Equipment?
- P
  Patrick HamiltonAug 27, 2025
  If you notice unusual noises coming from your Blastrac Industrial Equipment, it could be due to several reasons. There might be too little clearance or incorrect adjustment of the rotating parts, so check their alignment and adjustment. Another possible cause is insufficient grease in the bearing, so lubricate it. Lastly, the silencer assembly might be defective, so check it and replace it if necessary.