Blastrac BDC-66 - Introduction; Machine Description

4
1. Introduction
It is important that all persons who are working or maintaining this machine read the manual carefully and
understand it fully.
Keep this manual near to the machine, so it can always be consulted.
Only authorized and trained personnel may operate this machine.
2. Machine description
The Blastrac dust collector BDC-66 can only be used for dry cleaning.
It should only be used for removing not-inflammable dust or substances.
The BDC-66 must not be used for carcinogenic or asbestos substances.
The machine is designed for usage in conditions according to classification M (see below).
Classification acc. standard EN 60335-2-69 – Annexe AA
Class
Designation
L
(Low risk ) for separating dust with an exposure
limit value of over 1 mg/m3, depending on the
volume occupied.
M
(BDC-66)
(Medium risk) for separating dust with an
exposure limit value of over 0,1 mg/m3,
depending on the volume occupied.
H
(High risk) for separating al dust with an
exposure limit value lower than 0,1 mg/m3,
depending on the volume occupied. Including
carcinogenic and pathogenic dusts.
Dust emissions into the environment
Class
Value of performance
L
Retains at least 99,1 % of particles measuring ≥ 3 μm
M
Retains at least 99,9 % of particles measuring ≥ 3 μm
H
Class H13 HEPA filter in accordance with EN1822
Application
The BDC-66 is especially designed to be used in combination with Blastrac machines.
And can also be used with every other type of machine.
Contact Blastrac B.V. for the correct execution and combinations.