Blastrac BMS-280LP - 4 Initial Operation; Checkpoints of Gas Cylinder Safety; Checkpoints of Machine Safety

8
4. Initial Operation
Befor each use it is essential to inspect the machine.
It is not permitted to use the machine if it does not pass all of the checkpoints below.
Checkpoints of Gas Cylinder Safety:
 Check the bottle for any damage before use.
 Ensure hose to gas cylinder is fully seated and sealed before turning on the bottle.
 Always turn the bottle completely on before starting the engine.
 Always turn the bottle completely off after using the machine.
Checkpoints of Machine Safety:
 Control levers should be in neutral position.
 All hydraulic hose connections are tightened and there is no leakage of oil.
 The safety functions and operating functions work correct.
 There are not any loose nuts or bolts.