Blaupunkt 368418 - TROUBLESHOOTING

The air cooler will
not power on.
10
TROUBLESHOOTING
Problem
The air cooler is not
connected to the mains
power supply.
The fuse has blown.
Possible Cause
Plug in and switch on the air cooler at
the mains power supply.
Replace the fuse with one of the same
rating.
No air is blowing from
the air cooler.
The desired cooling speed
has not been selected.
Press any one of the cooling speed
buttons named LOW-HIGH, HIGH
being the strongest cooling speed.
The air blowing from
the air cooler is not
strong enough.
The cooling speed is set too
low.
The mesh lter is blocked.
Select a higher cooling speed by
pressing the relevant cooling speed
button.
Clean the mesh lter or evaporation
pad following the instructions in the
section entitled ‘Care and
Maintenance’.
The air cooler is not
cooling the air.
The humidier function has
not been selected.
The water tank has not been
lled with enough water.
The ice packs are not / full
with water.
Ambient humidity is high.
To activate the humidier function,
press ‘HUMIDFY’.
Fill the water tank to the max. ll
mark.
Fill the ice packs with water so that
they are / full; allow to freeze for
approx. 8 hours before use.
The air cooler will not be able to cool
due to the high humidity in the air.
The vertical grills are
not turning left and
right.
The swing function has not
been selected.
Activate the swing function by
pressing ‘SWING’.
Solution