Blaupunkt 368418 - INSTRUCTIONS FOR USE; Filling the Ice Cube Plus Personal Space Cooler

4
INSTRUCTIONS FOR USE
Before lling the air cooler, make sure that it is switched off and unplugged from the mains power
supply.
STEP 1: Open the water tank at the back of the air cooler by twisting the water tank lock, carefully slide
the water tank out just under halfway, checking that the water pump cables are not being either
stretched or trapped.
STEP 2: Using a suitable measuring vessel, ll the water tank with cold, clean water. The water level
should be no lower than the min. ll line and no higher than the max. ll line. Alternatively, open the
water tank top lid and ll the water tank with cold, clean water. Water lled this way will run over the
evaporation pad before draining into the main water tank.
STEP 3: The two ice packs can be used to achieve quicker, additional cooling; they should be � full of
water and left to freeze for approx. 8 hours before use. Place them into the water tank before it has
been lled with water.
STEP 4: To close the water tank, carefully push it back into position and twist the lock to make sure that
it is secure.
Caution: Do not ll the air cooler with any liquid other than cool, clean water. Do not use any additives
in the water.
Filling the Ice Cube Plus Personal Space Cooler
STEP 2
STEP 1
STEP 3