EasyManua.ls Logo

Blaupunkt B50/211TCS - DVD Menu*; General Setup Options; Audio Setup Options; Dolby Digital Settings

Blaupunkt B50/211TCS
80 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
too far).
TIP: When you switch the TV to standby or change channel the Time Shift
memory is wiped. To restart time shift you must press play/pause button.
One Button Record
At any point in time you may decide to record the current channel that you
are watching. To do this you need to press the [REC] button.
TIP: This television contains one TV tuner, therefore it can
only record the channel you are watching or record one
channel while the television is in standby mode.
Note: USB record function is only available in Digital TV mode. Due to
copyright laws and illegal copying/recording it is not possible to record to/
from any other input/output source.
DVD Menu*
To access this menu, press [D. MENU] button on the remote control.
If you wish to make changes to any of the default settings, use
the scroll /// buttons. To con rm any settings press [OK]
button. To exit this menu at anytime, press [EXIT] button.
General Setup Page
TV Display - Choose from the following options 4:3
PanScan - PS Traditional picture format, often used on old  lm
4:3 LetterBox - LB Traditional picture which
has been adapted for widescreen
Wide - Widescreen picture format
OSD Language - Select desired language
Audio Setup Page
Speaker Setup - Choose from the following options
LT/RT - Set LT/RT Downmix
Stereo - Set Stereo Downmix
Dolby Digital Page
Dual Mono
Stereo - Outputs 2 channels of sound both left and right
Mono L - Outputs left side sound
Mono R - Outputs right side sound
Mix Mono - Outputs a single channel of sound
but mix between right and left
Dynamic Range - This is the di erence between the quietest and loudest
sounds. This setting works only with DVD discs recorded in Dolby digital.
Preference Page
TV Type - Choose from the following options
NTSC - Normally used for discs from North America, Japan etc
PAL - The standard for discs from UK/Europe, most of Asia, Australia etc
Multi - For both NTSC and PAL
Default - This option allows you reset all DVD settings to factory settings.
*- only for devices equipped with built in DVD Player

Related product manuals