EasyManua.ls Logo

Blaupunkt BT Drive Free 111 - Declaration of Conformity; LED Indicators; Resetting the BT Drive Free 111

Blaupunkt BT Drive Free 111
56 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 19
ENGLISH
Setting the volume
During a call, repeatedly press the "+" or "–" button on the BT Drive
Free 111.
Mute on/o
To mute the microphone, press the MODE button. The red LED starts
ashing.
To switch the microphone on again, press the MODE button again.
Call transfer
From BT Drive Free 111 to cell phone: During a phone call, press the volume
buttons +/– at the same time to transfer the call to the cell phone.
From cell phone to BT Drive Free 111: Press the MFB button and the call
is transferred.
Resetting the BT Drive Free 111
To reset the device to factory settings, proceed as follows:
The BT Drive Free 111 must be in standby mode.
Press the volume buttons +/– at the same time for approx. 10 seconds
until the LED alternately  ashes red and blue.
Press the two volume buttons again at the same time for approx. 2 seconds
until two short sounds are emitted and the LED stops  ashing. The BT Drive
Free 111 switches o and the factory settings are restored.
After resetting the device and switching it on again, the red LED  ashes
every 3 seconds and 3 sounds are emitted every minute. This is normal
and ends again with the next pairing.
LED indicators
Device status Red LED Blue LED Sounds
OFF mode O O
Switching on On for 3 sec. Short sound
Switch-o On for 3 sec. Long sound
Standby before
pairing
Flashes every
3 sec.
3 sounds every
minute
Standby after
pairing
Flashes every
3 sec.
Standby –
battery nearly
depleted
Flashes every
3 sec.
3 sounds every
minute
During a call Flashes every
15 sec.
During pairing Flashes alternately
Pairing
terminated
Flashes every
3 sec.
Long sound
Mute Constantly on
While charging Constantly on
Charging
complete
O O
Declaration of conformity
The Blaupunkt AudioVision GmbH & Co. KG declares that this product complies
with the basic requirements and the other relevant regulations of the direc-
tive 1999/5/EC. The declaration of conformity can be found on the Internet
under www.blaupunkt.com.
02_BTDriveFree111_gb.indd 18-1902_BTDriveFree111_gb.indd 18-19 04.11.2010 9:13:25 Uhr04.11.2010 9:13:25 Uhr

Table of Contents

Related product manuals