Note: As soon as the charger is connected, the BT Drive Free 112 switches off.
During the charging process, the MF button lights red. After the battery is full charged, the MF
button lights blue. The charging process of the battery lasts approx. 3 hours. Disconnect the BT
Drive Free 112 from the charger after it has been charged.
A completely charged battery supports a talk time of up to 15 hours and a standby time of up to 500
hours. If the charge state of the battery becomes low, the MF button flashes red every 3 seconds and
you hear a warning beep every 20 seconds.
19
Note:
ForusingtheBTDF112withiPhoneorBlackberry,anadditionalbatterymeterfeaturewill be
activated,theremainingbatterycapacitywilldisplayonyourphone.
Switching on/off
Switching on
To switch the unit on, press the MF button for approx. 3 seconds until you hear a high-pitched signal
tone and the MF button lights blue. Afterwards, the MF button lights blue and the device are
switched on.
Switching off
To switch the unit off, press the MF button for approx. 3 seconds until you hear a low-pitched signal
tone and the MF button lights red. Afterwards, the device is switched off.
Registering (pairing) and connecting with the cell phone
Before you can use the BT Drive Free 112, you must register and connect it with a Bluetooth-ready
cell phone. Registering is a one-time process and required only for the first connection with the cell
phone. The BT Drive Free 112 can be registered with up to eight cell phones and be connected
simultaneously with two cell phones.
– Hold the BT Drive Free 112 within range of a Bluetooth-ready cell phone; the distance should