10
Using the BT Drive Free 112
After successfully completing the registration and charging the battery, the
following functions can be executed:
Making a call
– Voice dialing*
To activate voice dialing, brie y press the MF button. You hear several
signal tones. After the signal tone, speak the voice command. After the
voice command has been recognized, the cell phone dials the number
associated with it.
Note: If two cell phones are connected with the BT Drive Free 112, the
voice commands are directed only to the cell phone connected rst.
– Redialling the last number*
Press the MF button twice. You hear a signal tone and the number dialled
last is being redialled.
Note: If two cell phones are connected with the BT Drive Free 112, hold
the "–" button pressed for 2 seconds to dial the last number of the cell
phone connected last.
– Call origination via cell phone
Select the desired number as usual via the cell phone. The call is automati-
cally transferred to the BT Drive Free 112.
Answering a call
To answer an incoming call, brie y press the MF button.
Ending a call
Brie y press the MF button to end a call.
Rejecting a call*
To reject a call, hold the MF button pressed until you hear a signal tone.
Adjusting the volume
During a phone call, adjust the volume with the buttons "+" and "–".
Muting the microphone
To mute the microphone during a call, brie y press the MODE button. The
MF button ashes red every 10 seconds and you hear two signal tones. Press
the MODE button again to cancel the muting.