Blaupunkt CDC-RF6IR - Page 10

45’ Installation
l Confirm that Anti-Vibration
Switches on both left and
right sides are set to
position 45.
l Attach brackets (L) and (R)
using the hexagonal bolts
(M5 x 8).
l Attach brackets (L) and (R)
to their respective
brackets (B) using the
hexagonal bolts (M6 x 20)
and the hexagonal nuts
(M6).
I
I
l Pull back the carpet and determine
where to attach the unit.
l Stick the supplied double-sided tape
to the bottom of the brackets (B) and
peel off the paper backing.
l Affix the unit to the floor by pressing
in place.
0
A
l Using a knife, cut Y’s in the carpet
directly above the brackets (B) bolts.
l Return the carpet to its original
position allowing the bolts to
protrude through.
Q
l Remove the hexagonal nuts and
take off the changer.
e
l Once more, use the hexagonal nuts
to attach the changer on top of the
carpet.
10