Blaupunkt Comfort 112 Wireless - Operating the Headphone System; Adjusting the Range of the Transmitter; Switching off the Headphone System

Operating the headphone system
To
listen
to
music
with
the headphone system, proceed
as
follows:
..-
Switch on the audio device and start the music playback.
Note:
Adjust
the
volume level
at
the
audio device
as
high
as
possible
without
having a
distorted sound.
If
the volume
level
is
set
too
low, the sound quality may be impaired
due
to
noise .
..-
On
the
transmitter, hold the<!>
button
pressed for 3 seconds.
The transmitter switches on. The power-on indicator lights
blue
if
the transmitter
receives sound signals .
..-
On
the
headphones,
hold the<!>
button
pressed for
3
seconds.
The headphones switch on and
the
power-on indicator flashes green. The power-
on indicator lights
as
soon
as
the headphones receive
the
sound signal from the
transmitter .
..-
Use
the
VOL+........_
-control
to
adjust the volume
of
the headphones
to
the desired
value.
Adjusting the range
of
the transmitter
You
can adjust
the
range
of
the
transmitter
with
the
LO/HI
switch. The maximum range
between transmitter and headphones depends on the ambient conditions and the
charging state
of
the battery .
..-
Select the
LO
setting for a
maximum
range
of
up
to
10
metres.
-Or-
..-
Select
the
HI
setting for a
maximum
range
of
up
to
30
metres.
Note:
With
the
HI
setting, the
power
consumption
is
higher
so
that
the operating
time
of
the
battery
is
reduced.
Switching off the headphone system
Switch
off
the headphone system after
use
to
save
the batteries and the rechargeable
battery .
..-
On
the headphones,
hold the<!>
button
pressed for 3 seconds.
The headphones switch
off
and
the
power-on indicator goes out.
..-
On the transmitter, hold the<!>
button
pressed for 3 seconds.
The transmitter switches
off
and
the
power-on indicator goes out.
Note:
If
the transmitter or
the
headphones
do
not
receive a sound signal for more than
10
minutes,
the
headphone system automatically switches off.
19