53
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
SETUP – BASIC SETTINGS
Activating the screensaver
The ME2 is equipped with a screensav-
er that prevents pictures (e.g. menus)
from “burning into” liquid crystal dis-
plays.
If the screensaver is activated, a Blau-
punkt logo is displayed approximately
60 seconds after the last action taken
by the user in order to prevent individu-
al pictures burning into the screen.
You can find the screensaver settings
under “SCREEN SAVER” in the “GEN-
ERAL SETUP” menu.
Resetting the device
You can reset the device thus clearing
all the settings you have changed.
Note:
● No DVD must be inserted.
➮ Open the setup menu.
➮ Use the buttons < to select
the “PREFERENCES” menu item.
➮ Confirm your choice by pressing
the ENTER/PLAY button B.
The preferences menu is displayed.
➮ Use the buttons < to select
the “DEFAULTS” menu item.
➮ Press the button <.
The “RESET” menu item is highlighted.
If you are sure you want to reset the
device,
➮ press the ENTER/PLAY button B.
The factory default settings are loaded.
Specifications
Operating voltage: 10.8 V to 23 V
Current consumption:
In operation: less than 2.0 A
During standby: approx. 3 mA
Operating temperature: 0˚C to +50˚C
Storing temperature: -20˚C to
+70˚C
Air humidity: 10% to 75%
Laser: 650 nm
Colour standards: PAL and
NTSC
Frequency range
Audio at 48 k: 4 Hz -
22 kHz
Audio at 96 k: 4 Hz -
44 kHz
Weight: 1.7 kg
Dimensions: 175 x 60 x
198 mm
Subject to changes.
SPECIFICATIONS
2.DVD-PlayerME2_gb 80%® 15.03.2005, 8:43 Uhr53
To Next Page
Loading...
