Blaupunkt DVD-PLAYER MEU2 - Wiring and Connection Details

35
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Connections
Connect the free ends of the supplied
connection cable to your vehicle’s pow-
er supply.
Yellow: Continuous positive power
source 12V
Black: Earth
Red: Ignition
The continuous positive power cable
between the battery and the ME2 must
additionally be protected directly at the
battery with a fuse holder (5 amperes).
Plug the connector plug into the 16-pin
socket on the left-hand side of the de-
vice.
You can connect the infrared receiver
for the remote control to the REMOTE
SENSOR 3.5 mm jack plug. The infra-
red receiver can then be installed any-
where in the vehicle.
Note:
If you have not installed the ME2 in a
concealed location in the vehicle, you
can also point the remote control directly
at the front of the device.
For audio/video playback, connect the
AUDIO/VIDEO OUT and DIGITAL OUT
cable connections to the appropriate
inputs of your system.
Additionally, you can connect external
audio/video sources to this set of ca-
bles (AUDIO/ VIDEO IN). For further
details, read the chapter entitled “Ex-
ternal sources”.
Connection socket
(16 pin)
Remote Sensor
INSTALLATION AND CONNECTION
Audio in Digital out
Audio out Video in/out
Earth (black)
Continuous positive power source (yellow)
Ignition (red)
2.DVD-PlayerME2_gb 80%® 15.03.2005, 8:42 Uhr35