Blaupunkt LS 2400 - Select Modes; Adjust the Volume; Select a Preset Sound Effect; AUX; OPTICAL; COAXIAL Operation

13
Select Modes
Press the SOURCE button repeatedly on the unit or press the HDMI (ARC), AUX, OPTICAL, BT (Bluetooth)
buttons on the remote control to select the desired mode.
- In AUX mode: the status indicator lights up Green.
- In OPTICAL mode: the status indicator lights up Orange.
- In COAXIAL mode: the status indicator lights up Orange flashes.
- In Bluetooth mode: the status indicator lights up Blue.
Adjust the Volume
- Press the VOL+ / VOL- buttons on the unit or on the remote control to adjust the volume.
- If you wish to turn the sound off, press the MUTE button on the remote control. Press this button
again or press the VOL+ / VOL- buttons on the unit or on the remote control to resume normal
listening.
- While adjusting the volume, the status indicator ashes quickly.
- While the volume level reaches its maximum level, if you press the VOL+ button again, the status
indicator ashes once. While the volume level reaches its minimum level, if you press the VOL-
button again, the status indicator ashes once.
Select a Preset Sound Effect
• While playing, press the FLAT, MOVIE and MUSIC button on the remote control to select desired
preset equalizers: MOVIE (recommended for viewing movies), MUSIC (recommended for listening to
music), FL AT (EQ mode off ).
- While select a preset sound effect, the status indicator ashes quickly.
• While using the OPTICA/AUX/COAXIAL connection, MOVIE EQ will be automatically selected.
• While using the BLUETOOTH operation, MUSIC EQ will be automatically selected.
AUX / OPTICAL / COAXIAL Operation
1 Ensure that the unit is connected to the TV or audio device.
2 While in ON mode, press the SOURCE button repeatedly on the unit or press the COAXIAL, AUX,
OPTICAL buttons on the remote control to select the desired mode.
3 Operate your audio device directly for playback features.
4 Press the VOL +/– button to adjust the volume to your desired level.
Tip:
• Make sure the audio setting of your source player (e.g. DVD player, game player, TV) is change to
"PCM" with the optical and coaxial output.