Blaupunkt Moby Blue S 0709E - Troubleshooting Common Problems; Common Issues and Solutions

MBS0709E, MBS12E
www.blaupunkt.com
24
Do not repair or disassemble the air conditioning by yourself. Unqualied repair will lead
to failure of the warranty card, and may cause damage to users or their properties.
Note:
If problems not listed in the table occur or recommended solutions do not work, please
contact the professional service organization.
Problems Reasons Solutions
The air condi-
tioning does not
work.
There is no electricity. Turn it on after connecting it to a socket
with electricity.
The overow indicator displays “FL”. Discharge the water inside.
The ambient temperature is too low or too
high
Recommend to use the machine in at the
temperature of 7-35°C (44-95°F).
In cooling mode, the room temperature is
lower than the set temperature; in heating
mode, the room temperature is higher
than the set temperature.
Change the set temperature.
In dehumidication mode, the ambient
temperature is low.
The machine is placed in a room with
an ambient temperature of greater than
17°C(62°F).
The cooling
eect is not
good
There is direct sunlight. Pull the Curtain.
Doors or windows are open; there are a lot
of people; or in cooling mode, there are
other sources of heat.
Close doors and windows, and add new air
conditioning.
The lter screen is dirty. Clean or replace the lter screen.
The air inlet or outlet is blocked. Clear obstructions.
Big Noise The air conditioning is not placed on a at
surface.
Put the air conditioning on a at and hard
place (to reduce noise).
Compressor
does not work.
Overheat protection starts. Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
The remote
control does not
work.
The distance between the machine and
the remote control is too far.
Let the remote control get close to the air
conditioning, and make sure that the re-
mote control directly faces to the direction
of the remote control receiver.
The remote control is not aligned with the
direction of the remote control receiver.
Batteries are dead. Replace batteries.
Displays ‘E1’. The room temperature sensor is abnormal. Check the room temperature sensor and
related circuitry.
Displays ‘E2’ The pipe temperature sensor is abnormal. Check the pipe temperature sensor and
related circuitry.