12
RADIO MODE
➮ Press the MENU button 7.
➮ Press the
or button 6 repeat-
edly until “SENS HI” or “SENS LO”
appears in the display.
“SENS HI” means that the tuner is highly
sensitive. “SENS LO” means it is set to
the lower sensitivity setting.
➮ Set the required sensitivity using
the
or button 6.
When you have finished making your
changes,
➮ press the MENU button 7.
Note:
● Different seek tuning sensitivities
can be set separately for FM and
AM respectively. To do so, activate
the relevant waveband.
Tuning into stations manually
You can also tune into stations manual-
ly.
➮ Press the
or button 6.
Storing stations
Storing stations manually
➮ Select the required memory bank
(FM1, FM2 or FMT) or the AM fre-
quency range.
➮ Tune into the station.
➮ Press one of the station buttons
1 - 6 9 for longer than 2 seconds
to store the station to that button.
Storing stations automatically
(Travelstore)
You can automatically store six stations
with the strongest reception in the re-
gion. The stations are stored in the FMT
or AM memory depending on the se-
lected frequency range.
Note:
● Stations that were previously
stored in this memory are deleted
in the process.
➮ Press and hold the BND•TS button
4 until the seek tuning starts.
The station storing procedure begins.
“FM TSTORE” or “AM TSTORE” ap-
pears in the display. After the process
is completed, the station that is stored
in location 1 of the respective memory
bank will be played.
Listening to preset stations
➮ Select the memory bank in which
the station was stored.
➮ Press the preset station button
1 - 6 9 of the station you want to
listen to.
Scanning receivable stations
(SCAN)
You can briefly play all the receivable
stations by activating the scan function.
You can set the scanning time to be-
tween 5 and 30 seconds in the menu.
To Next Page
Loading...
Need help?
General
