39
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Scanning tracks (SCAN)
You can briefly listen in to all the tracks
on a CD.
➮ Hold down the OK button ; for
more than two seconds. The next
track starts to play.
Note:
● The scanning time is adjustable.
Read about setting the scanning
time in the section “Setting the
scanning time” in the chapter “Ra-
dio mode”.
Stopping SCAN and continuing
playback
➮ Press the OK button ; to end
scanning.
The current track will then continue to
play.
Repeating a track (REPEAT)
➮ If you would like to repeat a track,
press button 4 RPT >.
“REPEAT TRCK” appears briefly on the
display, the RPT symbol lights up. The
track is then repeated until RPT is de-
activated.
Stopping REPEAT
➮ If you would like to end repeat,
press the button 4 RPT > once
again.
“REPEAT OFF” appears briefly on the
display, the RPT symbol goes out. Nor-
mal playback is resumed.
Interrupting play (PAUSE)
➮ Press the button 1 >.
“PAUSE” appears on the display.
Ending Pause
➮ Press the button 1 > during the
pause.
Play then resumes.
Changing the display
➮ To alter the display between track
number and time or track number
and playing time, press the
/
DIS 7 button once or several
times for more than two seconds
until the desired elements appear
on the display.
Traffic announcements in CD
mode
➮ If you want to receive traffic an-
nouncements whilst listening to a
CD, press the TRAF ? button.
Traffic announcement priority is active
when the traffic-jam symbol lights up on
the display. Please see the chapter “Traf-
fic information”.
Removing a CD
➮ Press the button 9.
The flip/release panel opens to the front
and the CD is ejected.
➮ Carefully remove the CD and close
the flip/release panel.
CD MODE
To Next Page
Loading...
