Blaupunkt Munich 100 - WIRING DIAGRAM; Connector Pinout; Connection Notes

WIRING DIAGRAM
•
•
•
•
•
This unit is desgined for 12V DC negative ground operation system only.
Before installating the unit, ensure vehicle is connected to 12V negative ground electrical system
The negative battery terminal must be disconnected before making connections.
This will help to prevent device from being damaged by short-circuit.
Ensure to connect the colour coded leads correctly according to the diagram.
Incorrect connections may cause unit to malfunction and may damage vehicle’s electrical system.
Ensure to connect the speaker (-) leads to the speaker (-) terminal.
Do not connect the left and right channel speaker cables to each other or the vehicle.
Do not block vents or radiator panels. Ensure good ventilation to prevent overheating.
10
*
A B
1 NC 1 Speaker out RR_
2 Telephone Mute 2 Speaker out RR-
3 NC 3 Speaker out RF+
4 Permanent +12V 4 Speaker out RF-
5 Auto Antenna* 5 Speaker out LF+
6 Illumination 6 Speaker out LF-
7 KI.15/Ignition 7 Speaker out LR+
8 Ground 8 Speaker out LR-
Switched power supply +12 V / max. 150 mA
1
3
5
2
4
8
7
6
12V
Relais
+12V
+12V
KI.15 +12V
Telephone Mute
4 ohms
4 ohms
4 ohms
4 ohms
Subject to change.