Users must check the PE detection mark " " on the display before each use.
(PE meaning protective conductor)
1.If the Mark " " is displayed on the screen, it indicates that the charger shall verify
the presence of the upstream PE, and the charging process will only begin when
the upstream PE is present.
2.If the Mark " " is NOT displayed on the screen, it indicates that the charger has
no function to verify the presence of the upstream PE, and can be charged
whether or not the PE can be detected.
ATTENTION: It is strongly recommended that users charge under condition 1.
Condition 2 has certain security risks due to the absence of PE. So Condition 2
should only be used under the premise that users can ensure safety and in
special circumstances where PE does not exist in the power system.
Deactivate PE Detection : Press “Amps+Time” for 4s together.
Reactivate PE Detection: Press “Amps+Time” for 4s together.
ATTENTION: if the mark " " appears, it means that the upstream PE has not been
detected and the charging cannot be started.
05
Explanation of the " " and " " symbol
To Next Page
Loading...
