Blaupunkt San Remo MP26 - Adjusting the Volume; Setting the Power-On Volume

35
DANSK
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Note:
If the vehicle ignition was switched
off prior to inserting the CD, you must
switch in on fi rst with the button 1
to start the playback.
Switching the device on/off using the
detachable control panel
쏅
Detach the control panel.
The device switches off.
쏅
Attach the control panel again.
The device switches on. The last setting
(radio, CD, CD changer or AUX) is reacti-
vated.
Adjusting the volume
You can adjust the volume in increments
from 0 (off) to 66 (maximum).
To increase the volume,
쏅
press the
button 3.
To decrease the volume,
쏅
press the
button 3.
Setting the power-on volume
Note:
The device features a time-out function
(time window).
For example, if you press the MENU
button 5 and select a menu item,
the device switches back after approx.
8 seconds after the last button activation.
The settings performed are saved.
You can set the power-on volume.
쏅
Press the MENU button 5.
쏅
Press the
or button 8 repeat-
edly until "ON VOLUME" appears on the
display.
쏅
Adjust the power-on volume using the
buttons 8.
To help you adjust the setting more easily,
the device will increase or decrease the vol-
ume as you make your changes.
If you enable "LAST VOL", the volume which
was set the last time you switched off
the device is re-enabled.
Adjusting the volumeSwitching on/off
02Milano_SRemoMP26_eng.indd 3502Milano_SRemoMP26_eng.indd 35 06.01.2006 13:04:03 Uhr06.01.2006 13:04:03 Uhr