The drive draws in the CD automatically.
You must not hinder or assist the drive as it
draws in the CD.
Gently close the control panel whilst
exerting a little pressure until you feel
it click into place.
The CD starts playing.
Note:
If the vehicle ignition was switched
off prior to inserting the CD, you must
switch the device on first with the but
-
ton
1 to start the playback.
If a CD is already inserted in the drive,
press the
SOURCE button 4 repeat-
edly until "CD" appears on the display.
Playback begins from the point at which it
was last interrupted.
Selecting tracks
Press one of the arrow buttons : to
select the next or previous track.
If you press the
or button : once, the
player will play the current track again from
the beginning.
Fast track selection
To quickly select tracks backwards or for-
wards,
press and hold down the
or
button
: until fast track selection
backwards / forwards begins.
Fast searching (audible)
To fast search backwards or forwards,
press and hold down the
or button
: until fast searching backwards / for-
wards begins.
Random track play (MIX)
Press the 5 MIX button ;.
"MIX CD" appears briefly on the display and
the MIX symbol is displayed. The next ran
-
domly selected track will then be played.
Cancelling MIX
Press the
5 MIX button ; again.
"MIX OFF" appears briefly on the display
and the MIX symbol disappears.
Scanning tracks (SCAN)
You can scan (briefly play) all the tracks on
the CD.
Press the
MENU button 9 for longer
than two seconds.
The next track will then be scanned.
Note:
You can set the scanning time. For
further information, please read the
section entitled "Setting the scanning
time" in the "Radio mode" chapter.
Cancelling Scan and continuing listening
to a track
To end the scanning process,
press the
MENU button 9.
The currently scanned track will then con
-
tinue to be played normally.
CD mode
To Next Page
Loading...
