60
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
To cancel the MIX function,
1 press the 2 MIX station button > again. The MIX function is automatically
cancelled if you activate the SCAN function.
Scanning all the tracks on a CD (SCAN)
If you briefly want to play (scan) all the tracks on a CD, proceed as follows:
1 Press and hold down the OK button ; for longer than 2 seconds.
✔ All the tracks on the CD are scanned in ascending order. The scanning time
is 10 seconds.
To cancel the SCAN function,
1 press the ESC button =. The SCAN function is automatically cancelled if
you activate the MIX function.
Repeating tracks (REPEAT)
To repeat a track, activate the repeat function.
1 Select the track that you want,
2 press the 5 RPT station button >.
✔ The track is repeated until you cancel the repeat function.
If you want to cancel the repeat function,
1 press the 5 RPT station button > again.
Traffic announcements during CD mode
To switch traffic announcement standby on/off (see the section entitled “Traffic
information” in the “Radio mode” chapter) whilst in CD mode,
1 press the TRAF button ?.
✔ The
symbol is shown in the display when traffic announcement standby
is activated.
TRACK 6
O:O8
scan CD
T
MC
TRACK 2
2:33
RP= =rack
T
MC
TRACK 7
3:24
CD
T
MC
4 BA TPAmsterd_gb 26.09.2005, 12:48 Uhr60
To Next Page
Loading...
