62
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
Each directory can be named using a PC. The device can display the directory
name if there are no ID tags available. You should name the directories and
tracks/files using the method provided by your CD burner software. The soft-
ware’s instruction manual will provide details on how to do this.
Note: When naming directories and tracks/files you should avoid
using accents and special characters since they might not be dis-
played correctly. You can use a maximum of 32 characters (includ-
ing the “.MP3” file extension) for track names and directory names.
Names that are longer than 32 characters cannot be displayed cor-
rectly.
MP3 tracks can contain additional information such as the artist, album and
track names (ID3 tags). This device can display ID3 tags of version type 1 and 2.
When creating (encoding) MP3 files from audio files, you should use bit rates up
to a maximum of 256 kbits/sec.
This device can only play MP3 files that have the “.MP3” file extension.
Notes: To ensure uninterrupted playback,
●
Do not try changing the file extension to “.MP3” of any files oth-
er than MP3 files and then attempt to play them! The device will
ignore these invalid files during playback.
●
Do not use “mixed” CDs containing both non-MP3 data and MP3
tracks (the device only reads MP3 files during MP3 playback).
●
Do not use mix-mode CDs containing both CD-audio tracks and
MP3 tracks. If you try playing a mix-mode CD, the device will
only play the CD-audio tracks.
4 BA TPAmsterd_gb 26.09.2005, 12:48 Uhr62
To Next Page
Loading...
