Blichmann Engineering, LLC 2016 BeerGun Owners Manual NEW-V1
For replacement parts visit blichmannengineering.com
Prior to Assembly / Disassembly
Ensure you have all the parts included in the table below. Please contact your retailer if any parts are missing.
Beer tube
Beer Hose – 10 ft anti-microbial
2
Note: The BeerGun® requires two outlets on your CO
2
tank as shown in Figure 9 below. Either a dual regulator
or a “Y” fitting setup will suffice. Regulators and “Y” fittings are not included with the product, but are available
through your retailer.
Caution:
Do not disassemble until you have fully read this manual. Do not use excessive force on any of
the parts during assembly or disassembly or they may be permanently damaged. The sheet metal valve clip
and the beer trigger are made of heat-treated stainless steel, but can still be deformed, and the tube grooves
can be permanently damaged or bent.
Do NOT use any cleaner or sanitizer containing chlorine such as bleach. Over time, this will pit and erode
stainless steel. Any other non-chlorine sanitizer is acceptable to use. Iodophor
TM
or StarSan
TM
both work very
well and do not require rinsing. In any case, a few minute soak is all that is needed to properly sanitize the
product. Extended soaking can lead to damage.
Prior to assembly, completely disassemble the filler and wash with a mild detergent. The included tube brush
makes it easy to clean the interior of the beer and CO
2
tubes. Rinse all parts well and soak in your preferred non-
chlorine, no-rinse sanitizer, including all the hoses and keg connectors.
To Next Page
Loading...