Blitz GHUSE Series - Page 11

Operating Instructions for Suspended Jacks
11
Transversely adjustable undercarriage
Transverse and height
-adjustable
undercarriage
B
A A

Insert undercarriage in rails and set track
width.
 Check the secure support of the castors
(standard castors min. 25 mm) over the entire
length of the rails.

Secure the undercarriage width with screws A
(2 pcs. per side) to 30 Nm.
 Screw side plates to desired height on the
undercarriage.

Tighten all screws B with a torque wrench to
80 Nm.

Insert undercarriage in rails and set track
width.

Check the secure support of the castors over
the entire length of the rails.

Se
cure the undercarriage width with screws A
(2 pcs. per side) to 30 Nm.
Transversely adjustable undercarriage
 Lift the jack into the undercarriage and lower
it (A) until the operating element [2] is just
below the guide rails
 Turn the jack 90° (B)
 Set jack down on the undercarriage
A
B