Operating Instructions for Suspended Jacks
6
1 Basic Safety Instructions
1.1 Intended Use
The jack is intended exclusively for partially lifting vehicles and for transporting vehicle parts
(engine, transmission). Any other use there of shall be considered as not intended use.
Always secure lifted vehicles with supporting bridges/A-frames.
1.2 Basic Measures
The lift may be used only by workshop personnel with corresponding training.
Work on electric, hydraulic, and pneumatic systems may be performed only by specialists.
Observe the operating instructions.
Always keep the operating instructions available at the place of use.
Observe all safety and danger notes on the lift and keep them legible.
The workshop operator must insure that all safety regulations are observed by the workshop
personnel.
Technological modifications of the lift are not permitted.
The operating instructions are a part of the product and must be handed over to a succeeding
user.
Observe the maintenance intervals.
1.3 Safety-relevant Components
• Hydraulic pressure limiting valve
• Hydraulic lowering brake valve
• Tilt protections [1] on the lifting cylinder
• Pull-out safety devices at the undercarriage ( 4.2, Positions A)
• Pressure limiting valve
• Throttle valve
• Tilt protections [1] on the lifting cylinder
• Pull-out safety device at the undercarriage ( 4.2, Positions A)
1.4 Explanation of Notes
DANGER
Risk of death and severe injury
Measures
WARNING
Risk of injury and material damage
Measures
CAUTION
Property damage
Measures
2 Storage
Store the jack in a dry place protected from the weather at an ambient temperature of -10 °C to +50
°C. Contact the manufacturer if storing for more than 6 months.
To Next Page
Loading...