To Next Page
J
Jesse BennettJul 31, 2025
What to do if my Blizzard Lighting Equipment has no power?
- SSamantha SmithJul 31, 2025
If your Blizzard Lighting Equipment has no power, check the fuse, AC cord, and circuit for any malfunction.
What to do if my Blizzard Lighting Equipment has no power?
If your Blizzard Lighting Equipment has no power, check the fuse, AC cord, and circuit for any malfunction.
What to do if my Blizzard Lighting Equipment is not responding or responding erratically?
If your Blizzard Lighting Equipment is not responding or responding erratically: * Make sure all connectors are seated properly and securely. * Use only DMX cables. * Install a terminator. * Check all cables for defects. * Reset the fixture(s).
What to do if my Blizzard Lighting Equipment has no light output?
If your Blizzard Lighting Equipment has no light output, check to ensure the fixture is operating under the correct mode, such as sound active, auto, DMX, etc., if applicable.
Why does my Blizzard Lighting Equipment auto-shut off?
The Blizzard Lighting Equipment may shut itself off due to high heat. Check the fan in the fixture. If the fan is stopped or moving slower than normal, clear any obstructions from the fan or return the unit for service.
What to do if my Blizzard Lighting Equipment has no response to audio?
If your Blizzard Lighting Equipment has no response to audio, verify that the fixture is in “Sound Active” mode. If applicable, adjust the audio sensitivity.
Why is the beam dim on my Blizzard Lighting Equipment?
If the beam is dim on your Blizzard Lighting Equipment, check the optical system and clean any excess dust or grime. Also, ensure that the 220V/110V switch is in the correct position, if applicable.
Guidance on connecting the fixture to a power source and voltage selection.
Essential safety guidelines for installation, usage, maintenance, and operation.
Explains the function of each DMX channel in the 14-channel mode.
Explains the function of each DMX channel in the 32-channel mode.
Information on suitable cables and specifications for DMX communication.
Step-by-step guide for connecting fixtures in a DMX chain.
Safety guidelines for securely mounting and rigging the fixture.
Setting the DMX starting address and selecting the DMX channel mode.
Operating the fixture in Auto, Master/Slave, or Sound Active modes.
Identifies common problems and provides solutions for the fixture.
General| Power Supply | Internal |
|---|---|
| Light Source | RGBW LEDs |
| Control Protocol | DMX512, RDM |
| Weight | 14.3 lbs |
| Voltage | 100-240V AC, 50/60Hz |
| Operating Temperature | -10°C to 45°C |
| Housing | Aluminum |
