INSTALLATION
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION
■ If the unit has recently been transported. Please let unit stand still for a minimum of 24 hours
before plugging it in.
■ Make sure that there is proper ventilation around the unit in the where it will operate.
■ Make sure all accessories are installed before plugging the unit in.
■ Please read through the manual in its entirety.
■ Disposal of old equipment should be done responsibly as per WEEE regulations and local
authority directives.
CABINET LOCATION AND INSTALLATION GUIDELINES
■ Unpacking
The unit is delivered on a pallet and shrink-wrapped. Documentation is inserted into a clear
pocket located inside the unit. Carefully remove the protective plastic film and cardboard from
the unit exterior and from the door opening surround making sure that any sharp instrument
used does not cause damage, plus remove any quality labels.
■ Install the unit on strong and leveled surfaces
－unit may make unpleasant noises if surface is uneven
－unit may malfunction if surface is uneven
－If the floor is not flat, please use something to make sure the base of this unit in horizontal
level
■ Install the unit in an indoor, well-ventilated area
－unit performs more efficiently in a well-ventilated area Ensure the maximum design ambient
temperature is not exceeded
－for best performance, please maintain clearance of 100mm / 4” on the back of the unit,
50mm / 2” on the top of the unit.
To Next Page
Loading...