Block AURORA - Default Settings; Software Update

53
Default settings
Selecting and confirming this item resets all settings to the factory settings.
Please use this function if you have problems receiving data from the Internet or the general operating
soware of the device. You should also perform this function if you want to resell the device. A restart aer
executing the factory settings restarts the setup wizard.
Software update
The Aurora regularly checks and informs you whether an update is available on the Internet. You can set this
function for manual update (not recommended), or to update the operating soware.
Setup Wizard:
Selecting and confirming this item starts the setup wizard. All settings that you then make overwrite the old settings.
Info
Selecting and confirming this item will show you technical information about the installed soware version,
the manufacturer ID of the device, and the name under which your device will be displayed on the network.
Backlight
Here you can separately adjust the brightness of the display during operation and in network standby mode.
1. Time until dimming: this value indicates the time aer which the backlight of the display darkens aer swit-
ching to network standby.
2. Display brightness: this item controls the brightness of the display during operation.