Blomberg DWT37300 - Installing the Side Trim Strips

8
USA
Adjust the front foot level with the adjusting
wrench to balance and raise the dishwasher to the
enclosure height.
Adjust the rear foot level with a screwdriver to
balance and raise the dishwasher to the enclosure
height.
Notice :
 Make sure the dishwasher is plumb and
notice dishwasher can be placed with a small
clearance under the counter top.
 Turning the screwdriver in the direction of the
black arrows will bring the dishwasher back feet
up.
 Turning the screwdriver in the direction of the
white arrows will take the dishwasher rear feet
down.
T20
A
B
6.4 INSTALLING THE SIDE TRIM STRIPS
1. Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side walls (Figure B).