BloomSky SKY1 - Technical Specifications; Camera; Sensors

A Hard Reset restores your device to factory settings. Press and hold the Wi-Fi button for about
5-6 seconds, or until the power indicator stays green. Release the button and after 2 seconds,
the power indicator will flash green again. After 1 more second, the Wi-Fi indicator will start
flashing red. Your device has now returned to the Wi-Fi Setting Mode.
Note: DO NOT manually power off device when resetting Wi-Fi. The device will automatically
restart and the Wi-Fi will return to a blinking red icon.
Technical Specifications
Camera
•
Ultra-wide angle HD camera built-in with 49-degree adjustable shooting angle and fisheye
lens
•
Capture sky pictures around every 5 minutes or upon sudden change of temperature, humidity
or precipitation.
•
Compressed time lapse video of sky view generated at end of the day
•
Turn on at dawn and turn off at dusk based on sunrise and sunset in your area.
Sensors
•
5-in-1 sensors measure temperature, humidity, barometric pressure, UV exposure, and
precipitation (detection only) with the following tolerances
•
Operating temperature range: -4°F (-20°C) to 131°F (55°C)
•
Temperature accuracy: ±3°C (max)
Problem
Solution
•
The Power indicator quickly flashes green 3
times, every 3 seconds
•
The battery is low and the device needs to
charge.
•
When the device is in Wi-Fi setting mode,
Network LED always shows orange color
and flash
•
The device cannot get the IP address from
router. Please confirm your router’s DHCP
function is enabled.
•
If the Network Indicator light continues to
flash red while you are completing setup.
•
The device can not receive the Wi-Fi
network information correctly. Please
confirm:
-
Your Wi-Fi is not on a 5 GHz band
-
Your device is close (within 5 feet) of
your router.
BloomSky TM

www.bloomsky.com
 of 6 12