6. SAFETY REGULATIONS
• Make sure that the machine is constantly supplied with water. Dry working
would cause serious damages to the machine seal system.
• Electrical connections must be carried out by skilled/trained personnel only.
• Never pull the power cord to disconnect the plug nor pull the hose to move
the machine.
• Don’t leave the machine in a low temperature place and protect it from frost
and general bad weather conditions.
• Avoid vehicles transit on the high pressure hose.
• While the machine is running do not cover it and avoid placing it where
there’s low air supply.
• If you are working indoors, it’s compulsory to install a fan to discharge the
exhaust gases outside.
• The fan terminal must not be obstructed. Don’t leave the lance or any other
object near the exhaust outlet.
• The nature of the gases as well as the high temperature are to be considered
very dangerous, the operator must thus be adequately informed in order to
avoid being scalded.
• Don’t leave the machine outside when it rains or when the weather conditions
are bad. The operators must wear protection clothes while using the
machine.
• Do not leave the machine for more than 15 minutes working with the gun
closed, the water temperature would increase rapidly causing serious
damages to the seal system.
• Each time the machine has to be switched off blow off the hose residual
pressure by using the gun.
• Don’t put the hands in front of the lance.
• Do not use different fuels other than the ones recommended by the
manufacturer.
WARNING !
• Don’t carry out any operation on the machine before having unplugged it.
• Don’t carry out any unwary operation on the electric cable and make sure the
same is not damaged.
• Never direct the high pressure water jet towards people, animals, electrical
installations or the machine itself.
• Use always only clean water. Dirty water and chemical corrosive products are
harmful for the machine.
To Next Page
Loading...