Micro
current
intensity is eniitted when the
sw'itch is in
the
"blue"
zone.
When
treating
with
micro current intensity. there
will
be
very little or
no feeline of stimulation,
even if
the
probe
is
located at the trigger or acupuncture
points.
It is recommended to begin treatment
with a Iow intensity
setting.
thereafter turning
the
"lNT"
control until a comfbrtable intensity
is reached.
In order to treat
patients, the
grounding
pole
must
be
attached
rvith
the
plugjack
to
the bottom of
the unit. The
patient must
hold the
grounding pole to conrplete the electrical
circuit which
then
activates the detection and stimulation
functions.
This
device
is equipped with a Polarity
change-over su'itch.
If
a
positive
(
i
tbr
tonification) or
negarive
(-
ibr sedation)
pulse
stimulation
is lequircd, simpll'set the switch
to
+
or
position.
The Digital
Display
chamber
is
located
on the rear
top
side of the unit,
it
f-eatures
a digital display
to show
the frequency
(from
I to 16 Hz) ofstintulation
during operation, and numerical
display
(maximum
around 500 when sensitivity adjustment to
highest range) to
show
the sensitivrtr ol
detection
during the
location of acupuncture
points.
10. Turn
off the
unit after
use.
Remove the batterv
from the unit when
the
device will
not be used
for
a
long
pcriod ol'tinre.
To Next Page
Loading...