EasyManua.ls Logo

Blue Pod Easy Touch - Daily Use; Before First Use; Coffee Preparation

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BEFORE FIRST USE
The product should contain all of the
following components at the time of
purchase:
- Coffee machine, including water tank
and drain tray
- User manual
- Milk canister
DAILY USE
FOLLOW INSTRUCTIONS ON NEXT PAGE FOR
COFFEE PREPARATION
HOW TO CLEAN COFFEE MACHINE
BEFORE FIRST USE
It is important you clean the unit before first use. Please note: the first time the machine
is used there may be an odour caused. This is entirely normal and will disappear after
a few minutes.
The Easy Touch Machine is pre-programmed with three default settings. Before making
a coffee the following instructions must be followed:
Rinse removable water tank (M) and milk tank (F) with warm water.
Rinse thoroughly. Fill water tank (M) and milk tank (F) with cold water.
Fill the water tank (M) with water and the milk tank (F) with fresh, cold
milk.
Place a container or a large cup under the espresso nozzle (G).
Plug in the connection plug.
Plug in the connection plug.
Ensure that the espresso machine has been switched on or in standby
mode.
Turn the ON/OFF switch to ON position (K) and wait until the LCD
displays ‘Please Select’.
Exit standby mode by opening the lever (A). Your espresso machine is
ready to be used when the LCD displays ‘Please Select’.
NOTE! The device is intended for normal household use. The machine
can be overheated if you prepare directly more than 10 espresso‘s
repeatedly.
When the control LCD displays ‘Please Select’ (approx. 70 seconds),
press brew button and release (E) to flush system.
If the machine is turned off, switch the ON/OFF button (K) and wait
until the LCD displays ‘Please Select’.
The capsule container tray (H) and drip tray (I) must be emptied and
rinsed out regularly.
Open the lever (A) fully and insert an espresso capsule. Then, close
the lever (A) fully.
WARNING: Using the machine when the water tank is empty is not
recommended!
Wait until the water cycle finishes. Repeat the process twice before
use. WARNING: Steam will be dispensed from (G).
Inspect the delivery for completeness
and visible damage. If the product is
incomplete or damaged, please call:
1800 800 255 or email sales@bluepod.
com.au immediately, and do not use the
machine. Before using the machine for
the first time, clean it as described
under the heading ‘“How to clean coffee
machine before first use.”
PH: 1800 800 255
bluepod.com.au
PH: 1800 800 255
bluepod.com.au