Blue Pod Easy Touch - Cleaning if Milk Frothing Device Is Blocked

Pull out the frothing pin (B).
If you cannot prepare cappuccino or café latte because no milk frothing is possible.
Please use following instruction to clean the device and it parts thoroughly.
Seperate milk frothing device housing (Q) in upper and lower part (R).
Remove the main frother device by pressing in gently each side of the
unit and then pulling towards you.
Wash parts (S) (B) by hand with warm water.
Pull out frother part (S) of the milk frothing device housing.
Do not remove the silicone from part (R) tube. If blocked, rinse all of
part (R) thoroughly with warm water.
Assemble all parts in proper order and install housing assembly onto
the unit and gently insert frother pin (B) correctly for proper operation.
CLEANING IF MILK FROTHING DEVICE IS
BLOCKED (continued)
CLEANING IF MILK FROTHING DEVICE IS
BLOCKED
Q | Milk frothing device housing upper part
R | Milk frothing device housing lower part
B | Frothing pin
S | Frothing part
Q
R
B
S
PH: 1800 800 255
bluepod.com.au
PH: 1800 800 255
bluepod.com.au