Name: Blue Rhino UniFlame SG380-2
Brand: Blue Rhino
Rating: 4 (1 reviews)

Questions and Answers:

B
banksbaileyJul 30, 2025
How to fix a Blue Rhino Grill ignitor that won't light?
- B
  bryan67Jul 30, 2025
  If the burner won't light using the ignitor, there are several possible causes. The wires or electrode may be covered with cooking residue; clean them with rubbing alcohol. The electrode and burners could be wet; wipe them dry with a cloth. The electrode might be cracked or broken, replace it. The wire might be loose or disconnected; reconnect it or replace the electrode/wire assembly. The wire could be shorting between the ignitor and electrode; replace the ignitor wire/electrode assembly. Finally, the ignitor itself might be bad; replace it.
S
Samuel SimsAug 6, 2025
What to do if Blue Rhino Grill burner won't light with a match?
- W
  wilsonjamesAug 6, 2025
  If your burner won't light with a match, it could be due to several reasons. First, check if the LP tank is empty. If it's not empty, there may be an obstruction of gas flow, so clear the burner tubes and check for any bent or kinked hose. The burner might be disengaged from the valve; reengage the burner and valve. Also, check for spider webs or insect nests in the venturi and clean it if necessary. Lastly, the burner ports could be clogged or blocked; clean the burner ports. Make sure that the coupling nut and regulator are fully connected by hand.
J
Jeffrey ColonAug 14, 2025
What to do if there's a sudden drop in gas flow in my Blue Rhino Grill?
- M
  Monica SkinnerAug 14, 2025
  First, check if your LP tank has gas. If the tank isn't empty, the excess flow safety device might have been activated. To reset it, turn off the burner knobs and the LP tank valve. Disconnect the regulator, turn the burner control knobs to HIGH, and wait one minute. Then, turn the burner control knobs off, reconnect the regulator, and check for leaks. Finally, slowly turn the LP tank valve on, wait 30 seconds, and light the grill.